Page 29
3M
™
Straight Line Laminator Single Head Manual
|
Original Assembly and Operation Instructions
Effective: August 2022
6.6 Setting the Track Position
Depending on which track on the product surface the adhesive tape is applied to, it is necessary to
adjust the position of the tape mounting (Figure 27A) and the adjustable deflection pulley (Figure 27B) .
Figure 27
Type
Core Mounting
SGA 500 R 05-30
SGA 500 L 05-30
SGA 500 R 30-55
3", 2" long
SGA 500 R 55-80
3", 3" long
Figure 28
1 . Loosen the lock nut M16x1, DIN 439, spanner size 24 (Figure 28A) . For counter-holding, there
is a slot on the other side of the threaded axle (Figure 28F) .
2 . Change the position of the adjustable deflection pulley (Figure 28B) by screwing the threaded axle
out or in .
3 . Tighten the lock nut M16x1, DIN 439, spanner size 24 (Figure 28A) again .
The adjustable deflection pulley is now positioned to the new bonding track.
4 . Loosen the lock nut M18x1, spanner size 27 (Figure 28C) at the tape mounting (Figure 28D) .
5 . Change the position of the tape mounting (Figure 28D) by screwing the threaded axle out or in .
6 . Tighten the lock nut M18x1, spanner size 27 (Figure 28C) again .
Die tape mounting is now positioned to the new bonding track.
NOTE:
Make sure that the stop of the tape is collinear with both settings (Figure 28E) .
A
B
A
B
F
C
D
E
