Downloaded from Projector.com
3M
™
Multimedia Projector MP7630
30
© 3M IPC 2000
Lamp Replacement
✓
Note:
For maximum lamp life, do not shock, handle or scratch the lamp glass when it is hot.
Also, do not use an old or previously used lamp as a replacement lamp.
WARNING
To reduce the risk of electrical shock, always turn off projector and disconnect
power cord before changing lamp.
To reduce the risk of severe burns, allow the projector to cool for at least 45 minutes before replacing the
lamp.
To reduce the risk of cuts to fingers and damage to internal components, use caution when removing lamp
glass that has failed and shattered into sharp pieces.
Caution
To reduce the risk of cuts to fingers and/or decreasing image quality by touching the lens, do not insert
hand into the empty lamp compartment when the lamp has been removed.
This lamp contains mercury. Consult your local hazardous waste regulations and dispose of this lamp in a
proper manner.
1. Turn the main power switch off and disconnect the power cord from the outlet.
2. Loosen screw and remove the lamp cover. If the lamp is hot, avoid burns by waiting 45 minutes
until lamp has cooled.
3. Loosen three screws designated by arrows below. (It is strongly recommended to use a magnetic-
headed screwdriver, if possible. Pull the handle to remove lamp housing. If the screws are not
loosened completely, they could damage your fingers. Do not insert your hand into the box after the
lamp is removed. If the optical parts inside are touched by hand, it could cause color unevenness, etc.
4. Replace the lamp with the new one, insert into projector, and tighten the screws. Firmly tighten
the lamp screws. Loose screws may cause a bad connection, which may result in a malfunction.
5. Re-install the lamp cover and tighten the screw. Do not turn on the power with lamp cover removed.
Whenever the lamp has been replaced, reset the total operation time of the lamp. Do not reset if the
lamp was not replaced, as this could cause breakage.
Maintenance
