12
3M™ MicroTouch™ Display C1700SS Installation Guide
3M Touch Systems Proprietary Information
Unpacking Your Touch Display
Carefully unpack the carton and inspect the contents. Your C1700SS Display includes the
following cables and accessories:
•
SVGA video cable
•
RS-232 serial communication cable (or USB cable if applicable)
•
Optional AC/DC power supply (12V DC output)
•
AC power cable
•
CD with touch software, documentation, and utilities
•
Hardware kit (includes mounting brackets, screws, washers)
Mounting the C1700SS Display
The C1700SS Display is designed to fit any type of enclosure. All C1700SS Displays are
encased in rugged metal instead of plastic, making them easy to integrate.
The display does not have a bezel to act as an interface with a front mounting surface. If
you need a bezel as a mounting interface, it may be purchased from 3M Touch Systems.
Please contact your sales representative.
The C1700SS Display includes a hardware accessory kit for mounting the unit into an
enclosure. The C1700SS hardware accessory kit includes four brackets, washers, and
screws. The mounting holes are located on the sides of the display and are threaded to an
M4 thread.
You can attach the brackets to the edges of the chassis. The brackets are slotted, allowing
the chassis to slide in and out. You can also rotate the brackets to various positions.
This unit has the 100mm VESA mounting pattern on the back case to allow for arm
mount capability.
Suggested Mounting for the C1700SS Display
Note:
Do not mount the chassis unit directly from the rear of the cover. Always use the
holes and brackets provided. Do not drill additional holes in the unit to mount brackets in
other locations.
