78-9000-5020-0 Rev C
11
Active Frequencies:
7550
577 Hz, 1 kHz, 8 kHz, 33 kHz, 82 kHz, 200 kHz
7550E (International)
577 Hz, 1 kHz, 8 kHz, 33 kHz, 82 kHz, 133 kHz
ALL indicates that the following active frequencies are transmitting simultaneously:
7550
577 Hz, 8 kHz, 33 kHz, 200 kHz
7550E (International)
577 Hz, 8 kHz, 33 kHz, 133 kHz
[T-4] Digital Display:
Indicator Flags:
These flags coincide with the operational mode of the transmitter.
Starting from bottom left to upper right; Ohm-meter [T-2], Voltage (at start up the
transmitter checks for foreign voltage), Output Level (no flag = normal output;
flag = high output; flashing flag = maximum output) and Trace mode [T-3].
Digital Display:
Indicates frequency, relative current, resistance, battery level and
voltage (if present on target).
[T-5] Output Level:
Cycles output power level.
Normal=No Flag; High=Flag; Maximum=Flashing Flag (indicated in Digital Display [T-4])
NOTE: An external 12-volt power source is required to obtain Maximum Output level.
[T-6] Output Jack:
Port for direct connect cables or Dyna-coupler cable.
[T-7] External Jack:
Port to connect cigarette lighter adapter cable, or rechargeable
battery (2200RB). Input voltage level: 9-18 VDC.
G. 3M
™
Dynatel
™
Locator 7573 Transmitter Keypad and Connector Definitions
off
+
-
o
Trace
on
on
Output Level
Dynatel
TM
7573
T-1
T-2
T-3
T-4
T-5
T-6
T-7
[T-1] off:
Turns unit off and performs battery test.
[T-2] on: Ohm-meter/Fault Locate/Tone:
Turns the unit on and cycles through the
following commands when pressed repeatedly.
Ohm-meter:
Measures the continuity of the trace conductor/pipe and its far-end
ground. It is also used to measure the fault resistance to earth.
Fault Locate:
In this mode, the transmitter sends two alternating locating frequencies
(577 Hz and 33 kHz) as well as fault signals 10 and 20 Hz.
Tone:
In the tone mode, the transmitter generates two frequencies simultaneously:
7573
577 Hz and 200 kHz signals.
7573E (International)
577 Hz and 133 kHz signals.
[T-3] on: Trace (frequency):
Turns the unit on and places the unit in Trace mode.
Select Frequency:
Press
Trace
[T-3] repeatedly to cycle through the transmitter's
active frequencies. The selected frequency will be displayed [T-4].