7
7.2.
Holding and routing the micro-modules
Pay attention to the position of the red holders on guiding pins (Fig.3
6
), Position
and push the holder, using the stick, on the guiding pin in order to maintain the
micro-modules in place. The ideal configuration, when possible, is to place the
same amount of micro-modules on each side of the pin, under the red holder
(Fig.3
7
).
Small tabs upward
To make the fibres entering into a tray, two paths are possible,
depending on where they come from and where they go.
Direct path: identification 1 (Fig.38).
Opposite path: identification 2 (Fig.38).
7.3.
Pathway of the fibres in the trays
The fibres can be distributed in the trays from the right or left of the organizer, according to the recommendations of
the network engineering (Fig.39 & 40).
7.4.
Management of the pigtails in the closure
Recommended order for the use of the ECAM Connect ports (Fig.41 & 42)
Fig.36
Guiding
pin
Using the plate Fig.38
1
2
2
Input & output at opposite sides Fig.39
Storage area
Lovage
Input & output at same side Fig.40
Storage area
Fig.37
BPEO S0 ECAM Connect / 4 SC/APC Fig.41
BPEO S0 ECAM Connect / 8 SC/APC Fig.42
1
2
4 3
5 6
7 8
1
3
4
2
