10
10.2
Securing the cover
Insert the cord into the dedicated holes on the cover and base, then make one or two nodes (Fig.62, 63, 64).
10.3 Identification of the closure.
An area is dedicated to the marking on the cover for an easy and quick identification of the closure (Fig.65).
The base of the closure provides the possibility to install an additional identification plate (right or left) (Fig.66).
It is also possible to secure the opening of the closure by the use of a simple plastic tie (Fig.67).
11.
Closing the closure
Check that all components are properly installed and secured.
Check that no fibres or micro-structure may be trapped and damaged between any parts while closing the closure.
Check that no stress and no tension is applied on any of the fibres.
Note:
Check that the gasket of the base is perfectly clean and well positioned and clean and check that the water
tightness area in the cover is also perfectly clean
Position the cover over the base of the closure.
Push down the cover in order to start engaging its side latches in the base.
Check, that the guiding pins are properly inside of their corresponding slots in front (Fig.68 & 69) and the rear (Fig.70
& 71) of the closure.
Push the dome of the closure down in order to clip the latches completely (Fig.72, 73 & 74).
Securing the cover Fig.62
Detail for base Fig.63
Detail for cover Fig.64
Marking area Fig.65
Additional identification Fig.66
Security Fig.67