GRIND
SAND
POLISH
Slide the abrasive tube
of your choice onto the
mandrel, starting from
the tip.
Note:
The FELT comes
permanently mounted
*
on a separate mandrel.
(*certain markets)
Mount the abrasive
1
Twist clockwise
onto the Spindle of the
JOOLTOOL using grip
areas at the bottom of
the mandrel.
DO NOT OVERTIGHTEN
Twist counter-
clockwise to remove.
2
Turn the JOOLTOOL ON
and enjoy quick and
easy grinding, sanding
and polishing inside
rings and tubular items.
Note:
Mandrel can also
be used while in
Horizontal Mode. (p.13)
3
Pinch the tip of the
mandrel then, using
your other hand, slide
the abrasive OFF
Restart at Step to
re-install another.
R
1
a
b
Use Step to remove
mandrel from Spindle
2.2
a
b
2.1
2.2
Turn JOOLTOOL ON
Mount on Spindle
Remove or Change
INSIDE-RING MANDREL & PEARL VISE
Toll Free: 1-85-JOOLTOOL
p.28
Buy supplies at WWW.JOOLTOOL.COM
HOW TO USE THESE ACCESSORIES
FOR SAFETY: POWER “OFF” BEFORE INSTALLING ACCESSORIES
Please use caution, common sense and keep safety a PRIORITY!
TURN KNOB TO ADJUST THE JAW
Clockwise to
close
Counter-clockwise to
open
Locate the guide hole at
opposite side of the knob.
Hole diameter is approx.
1mm (0.039in)
Drill pearls using a 1mm bit through the
guide hole. Stones can be drilled using
Diamond Burrs through the open sides
of the Pearl Vise. (See below)
Close
the vise for
small
pearls or stones
Open
the vise for
larger
pearls or stones
PEARL VISE INSTRUCTIONS
INSIDE-RING MANDREL INSTRUCTIONS
(Items shown may be sold separately, may appear different than pictured below and may be discontinued without notice. Visit www.jooltool.com to check availability.)
(Pearl Vise May be sold separately)
PEARL
VISE
DRILL BIT
PEARL
or STONE
Handpiece
1
2
3
ANIE’S TIP:
After making a Pilot
Hole (initial small hole),
you can rotate your
piece, then drill larger
holes using the open
sides of the Pearl Vise.
FOR SAFETY: ALWAYS KEEP FINGERS AND BODY PARTS AWAY FROM DRILLING DIRECTION!