North American - ENG
Date Released:
05-22-18
3M-Matic
™
Accuglide 3 - 2 Inch Taping Head - Type 10800
Page 15
44-0009-2070-0 / ECO#0078483
Applying Mechanism Spring
To obtain access to spring, remove
taping head cover (four mounting
screws). Replace cover to
fi
nish.
The applying mechanism spring,
shownin
Figures 5-4A and 5-4B
,
controls
applying/bu
ffi
ng roller
pressure on box and returns the
mechanism to reset position. The
spring pressure is pre-set, as shown
in
Figure 5-4A
for normal operation,
but is adjustable. If a tape gap
appears on trailing surface of box
increase spring pressure. If front of
box is being crushed by applying
roller decrease spring pressure.
Removing spring end loop from
spring holder and placing loop in
other holes provided to adjust
spring pressure (see
Figure 5-4B
.
One-Way Tension Roller
Figure 5-5
The one-way tension roller is factory
set. When replacing this assembly,
the roller must have 0,5 kg [1 lb.]
min. tangential force when turning.
To Adjust Tension:
1. Wrap a cord or small strap
(non-adhesive) 4-6 turns around
the
tension
roller.
2. Attach a spring scale to the end of
the cord or strap.
3. Turn adjusting nut (with socket
wrench provided) until required
force of approximately 0.5 kg to
0.9 kg [1 to 2 lbs.] is reached to
turn roller pulling on spring scale.
Figure 5-4 Applying Mechanism Spring
Figure 5-5 One-Way Tension Roller
(Adjustments
continued
on next page.)
0.5 - 0.9kg
[1/2 lbs.]
Adjusting Nut
A
B
Adjustments
(continued)
• To reduce the risk associated with
shear, pinch, and entanglement hazards
- Turn air and electrical supplies o
ff
on associated equipment before
performing any adjustments, mainte-
nance, or servicing the taping heads
- Never attempt to work on the taping
head or load tape while the box
drive system is running
Warning
