Research & Development
Command
Description
Value
Error correction disabled.
ec=0
Disable binary file transfer.
bf=0
Minimum scan time/line: 0 ms.
st=0
Minimum scan time/line: 5 ms.
st=1
Minimum scan time/line: 10 ms (normal); 5 ms (fine).
st=2
Minimum scan time/line: 10 ms.
st=3
Minimum scan time/line: 20 ms (normal); 10ms (fine).
st=4
Minimum scan time/line: 20 ms.
st=5
Minimum scan time/line: 40 ms (normal); 20ms (fine).
st=6
Minimum scan time/line: 40 ms.
st=7
+FDCS=
vr,br,wd,l
n,df,ec,bf,st
Current session parameter; refer to +FDCC command.
+FDIS=
vr,br,wd,ln,
df,ec,bf,st
Current session negotiation parameter; refer to +FDCC
command.
+FDR
Receive phase C data command; initiates document reception.
+FDT=
df,vr,wd, ln
Transmit phase C data command: release the DCE to proceed
with negotiation.
+FET=
n
End of page or document command:
More pages; same document.
n=0
End of document; another document follows.
n=1
No more pages or documents.
n=2
Procedure interrupts; another page follows.
n=4
Procedure interrupts; end of document, another document
follows.
n=5
Procedure interrupts; end of document.
n=6
+FK
Regular fax aborts command.
+FLID=
"string"
Local ID string parameter.
+FLO=
n
Flow control options:
No flow control.
n=0
Set XON/XOFF software flow control.
n=1
Set CTS/RTS hardware flow control.
n=2
+FLPL=
n
Document for polling command:
The DTE has no document available for polling.
n=0
Indicate a document available for polling.
n=1
+FMDL?
Request DCE model.
+FMFR?
Request DCE manufacturer.
+FMINSP=
n
Minimum phase C speed parameter:
2400 bps.
n=0
4800 bps.
n=1
7200 bps.
n=2
9600 bps.
n=3
12000 bps.
n=4
14400 bps.
n=5
+FPHCTO=
<value>
DTE Phase C response time-out:
Determine how long the DCE will wait for a command after
reaching the end of data when transmitting in Phase C.
<value>=0 to 255; 100 ms units.
0-255
+FPTS=
n
Page transfer status
Received page good.
n=1
Page bad; retrain requested.
n=2
Page good; retrain requested.
n=3
Page bad; procedure interrupt requested.
n=4
Page good; procedure interrupt requested.
n=5
+FREL=
n
Phase C received EOL alignment:
The EOL patterns are bit aligned as received.
n=0
The last received bits of EOL patterns are byte aligned by the
DCE, with necessary zero fill bits inserted. Refer to TIA PN-2388
for details.
n=1
+FREV?
Request the DCE revision identification.
+FSPL=
n
"Enable polling" command:
Page
21
of
21
Revision 1.0
2003/6 From 3JTech
