background image

Ver 1.0.0.3 

 

Since 1988 

3. LED Description of the Rear Panel 

 

 

LED 

Color 

Status 

 POWER(

Yellow  Lit when +8V DC power is on and working. 

  LAN Link (

Yellow 

Lit when the cable connection with device exists. 

Flash when the data is transmitting.                 

Off when no cable connection exists. 

 

WLAN(Wireless LAN

)

 

Yellow 

Lit when the WiFi function is enabled. 

Flash when the data is transmitting.                 

Off when the WiFi function is disabled.              

  Pick Up/Hang Up (

)

 

Yellow 

Lit when picking up the connected analog phone.   

Off when hanging up the connected analog phone. 

 SMS(

Yellow 

Lit when receiving any new SMS(s). 

Off at any status except the incoming of new SMS(s).

 

3G PPP Status (

Yellow 

Lit when dialup is connected. 

Flash when the data is transmitting.                 

Off when dialup is disconnected.                  

6 Cellular Signal Strength LEDs

 

Low (

 

Yellow 

All 6 LEDs lit when the signal strength is good.     

(The LEDs lit would decrease progressively upon the 

signal strength) 

Medium (

High (

Summary of Contents for HSPA FWT WiFi AP

Page 1: ...Quick Setup Guide NOTE Please notify your sales representative immediately if any items listed above is missing or damaged 2 Hardware Connection Settings 1 Connect PC to LAN port of your HSPA FWT WiFi AP using a RJ 45 cable 2 Make sure the SIM card has inserted to the modem and the modem is ready as well 3 Connect the power cable to the power connector of your HSPA FWT WiFi AP 4 For using the Fixe...

Page 2: ...s transmitting Off when the WiFi function is disabled Pick Up Hang Up Yellow Lit when picking up the connected analog phone Off when hanging up the connected analog phone SMS Yellow Lit when receiving any new SMS s Off at any status except the incoming of new SMS s 3G PPP Status Yellow Lit when dialup is connected Flash when the data is transmitting Off when dialup is disconnected 6 Cellular Signa...

Page 3: ...t 2 Initiate your Internet Explorer and type in the address 10 10 10 254 3 Please input admin as the user name and the password Click OK button to enter AP s setup page 4 Once you are in the setup page please select Internet Settings and enter WAN section of the setup 5 In 2G 3G ISP SETTINGS please contact your ISP for the dialup settings User must enter Access Point Name APN Dial Number Username ...

Page 4: ...SPA FWT WiFi AP provides a RESET button that will be easy for users to reset the AP to default The button is located at the front panel of the AP See the figure below Reset steps are as follows 1 Press the RESET button 2 seconds around 2 All LEDs on the rear panel will flash 5 times 3 The AP will start to reboot NOTE Disconnecting the power before resetting which takes about 60 seconds is complete...

Reviews: