Bottom of Side Panels
2. Left Side Top Panel
The enclosure was designed to feed filament from the left side for the best access to
the extruder. You can also customize it yourself to feed from the top or right. Note the
cutout on the bottom left, which is designed to fit the R1 design. If you have the newer
design where this isn’t needed, the corner brace will simply cover it up.
Left Top Side Panel with Filament Slot
This is the first 1/8” panel to fit inside the 20x20 slots. Since 1/8” is much smaller than
slot, to prevent rattling while printing, use the included rubber trim to seat the acrylic.
Copyright 2018 3DUpfitters
9
