that the vertical height of the acrylic has been carefully measured to fit the factory
specification. If there doesn’t appear to be enough vertical room for either the upper or
lower front door acrylic you may need to adjust the height of the horizontal 20x20
braces as described in the Before You Start section.
4. Connect the Hinges
Attach the black hinges to the frame piece using the provided countersunk hex screws.
Loosely tighten since the door will be adjusted in a later step.
5. Attach Doors
Each door has holes to fit two hinges each. Using the same countersunk screws,
attach the doors to the hinges. This time securely tighten the screws, but do not over
tighten as the acrylic may crack.
6. Upper and Lower Latch Mounts
The doors will be held shut by magnet-style latches held in place by 3D printed
mounts. Each mount is labeled as either Upper or Lower, and attaches to horizontal
20x20 beams as shown below.
Copyright 2018 3DUpfitters
5
