Attach the door knob by first inserting the square M4 nut
into the slot. Use a 16mm cap head screw to attach the
door.
Now that the latches are mounted it is time to connect the
strike plates. Each plate comes with a squishy adhesive
covering the same size of the plate. Carefully attach the
adhesive side to the acrylic at the location of each latch.
Then,
adjust the width of the metal strike plate so that
it is held on by the pressure of the two sides of the
plate
. The adhesive covering will keep the metal strike
plate from scratching the acrylic.
3. Attach Left Side
Before attaching the left side you
need to place the left-side air intake
vent under your printer. It should
line up with the slits on the left-side
of the electronics case.
Lift up the printer and slide the vent
loosely into place. It will rest on the
table, and from there it curves upward to meet the slit position exactly.
This vent will be the main port to bring in cool air during a print.
The one tricky bit is the vent will attach on the outside of the panel, so you’ll want
to slip the panel over the vent.
Copyright 2021
3DUpfitters LLC11
