Assemble Panels
1. The Front Panel
Each of the corners of the enclosure will be held
together by the connectors pictured below. Only
two versions, L and R, can be identified by the
letters stamped inside. The opposite connectors
are identical, i.e., the Bottom Right is the same as
Top Left. In all cases, the surface of the
connector with the cutout pattern faces front or
back.
Note:
The Ender 3 S1 Pro and Plus models will
not have a front vent
as described earlier.
The front door is designed so that the latches are on the left. Attach the corner
connectors on the
back side
of the door frame using the provided cap head 12mm
screws. See the photos below. The top of the connector should be flush with the top
of the acrylic.
There are also smaller connectors at the top and right sides when viewed from the
front.
The front should look like the picture to the right.
Again, please note that the Ender 3 S1 Pro and Plus
models will not have a front vent.
Copyright 2023 3D Upfitters LLC
7
