5. Top Panel
Before attaching the top, now is an
excellent time to insert the support beam.
It is a tad wider than the enclosure so that
it doesn’t fall out when moving the
enclosure.
Use access through the doors to attach the top of the enclosure using M4 12mm
screws. You’ll also connect the top on the four corners to each mid-panel connector.
The slit is towards the front, and the small access hole for the filament runout sensor
cable should be on the right. The view on the right is from above, facing the front of
the printer.
Attach the filament sensor to the L-
bracket using the silver screw supplied
with the printer to attach the sensor to
the Creality spool holder.
Instead, you can use any spool holder
on top of the enclosure and run the
filament through the filament sensor and
directly to the extruder. Note: 3D
UPfitters spool holder not included.
Copyright 2023 3D Upfitters LLC
16
