2. Left Side Panel
Note: the ender 3 S1 Plus model has a vent on the left side, while the other two
models do not.
Attach the left side to the front forming an L-shape that will stand up on its own, then
attach one L and one R connector at the back. The Ender 3 S1 design technically
doesn’t need a door, but it allows for additional access to the extruder. The latch
mounts are smaller than the front, although the magnetic latch attaches in the same
way with wood screws. The parts for the side door will be in a separate packet.
Attach the door hinges, latch mounts, strike plates, and
knob; the assembly will look like the illustration to the right.
Don’t forget the mid-panel connectors at the back, left,
and top.
As with the front door, adjust how the door hangs by
loosening the hinge screws, using the strike plates to hold
the door to the latches, and then tightening the hinge
screws.
Copyright 2023 3D Upfitters LLC
10
