24
3dscentral.3dsystems.com
8.3 Add Cleaning Solution
If there is not enough cleaning solution, ZPrint displays
ADD
CLEANING SOLUTION
in the
Printer Status
dialog.
Important:
Do not add cleaning solution unless you are
prompted to in the ZPrint
Printer Status
dialog.
To add cleaning solution, follow the steps below.
1.
Open the lower door (under the Build Chamber).
2.
Pull the empty cleaning solution cartridge out of its housing
on the printer.
3.
Get a new cleaning solution cartridge. Check the label for
the expiration date, and for the correct orientation.
4.Insert the car-
tridge into its hous-
ing. Ensure the
cartridge is pushed
all the way in. You
should feel it gently
snap into place.
Important:
If a cartridge does not snap into place,
do not
force it
. Check the orientation and that it is the correct type
and try again.
8.4 Replace the Waste Tray
If the Waste Tray is Full, ZPrint displays
EMPTY WASTE TRAY
in
the
Printer Status
dialog.
To replace the Waste Tray, follow the steps below.
1.
Open the lower door (under the Build Chamber).
2.
Pull the full Waste
Tray out of its
compartment on
the printer.
3.
Insert a new
Waste Tray into its
compartment.
Ensure the Tray is
pushed all the way
in.
