3D Systems, Inc.
16
Electrical Cabinet
Main Power Disconnect:
The disconnect enables you to turn off all power to the system.
For safety reasons, the machine should be positioned to allow easy access to this switch.
Computer:
A computer which controls the printer is located inside the electrical cabinet. The user does not have direct access
to this device. The touchscreen user interface provides all user functionality.
Reset Button:
Reset Home recalibrates the home positions of the left and right side. If the left and right side motors of the
recoater blade get out of synch you would need to reset. You would be able to tell if the blade is askew.
Power Supply:
This module distributes all the AC power that the system needs. Circuits for the various subsystems are located
in this module.
Manual Offload Cart
The
manual offload cart
is included in the base configuration of the ProX 950.
The offload cart allows you to easily remove the print platform when it is loaded
with a large or heavy part and transport it to the finishing area where supports
are removed and the part is cleaned before it is cured.
All parts must be offloaded with the manual offload cart to ensure optimal safety.
To Remove a Part
1. Navigate to
Tools > Elevator/Leveler Settings
click on
Move
to Offload
. This will move recoater down 2” and platform up.
NOTE: the
Move to Offload
settings are already set in
the software . If additional changes need to be made,
follow steps in
Set Offload Position
.
NOTE: Always wear nitrile gloves when removing the
platform . If any build material gets on skin, wash skin
immediately with soap and water .
2.
Ensure there is enough room to slide offload cart under
platform without touching tabs on recoater.
3. Unlatch platform from forks by pulling latch handles toward
you.
4.
Slide Manual Offload Cart under platform.
5. Using handles on cart carefully pull platform out of machine.