3D Systems, Inc.
20
4.
Allow 1-2 minutes for the device to automatically configure the Device Drivers with your Operating System and connect.
NOTE: This configuration only occurs the first time you connect your device.
5. Ensure that the Geomagic Touch Status Indicator Light is lit (it will either be blinking yellow or solid orange if working properly). If it
is not, check all of the connections. If the problem persists, contact Customer Support.
ALTERNATE CONNECTION #3: THE NETWORK IS CONNECTED THROUGH THE
TOUCH DEVICE
NOTE: If you are using a GB network, this configuration may slow down network speed to 100MB.
1. Position the Geomagic Touch device in your workspace, using both hands to grasp the covers and base of the device. See
“PROPER HANDLING AND POSITIONING OF THE GEOMAGIC TOUCH DEVICE” on page 10
for instructions on how to
handle the device to reduce the risk of damage.
2. Attach the straight end of a supplied Ethernet Cable to any Ethernet Port on the supplied Network Switch.
3. Connect an Ethernet Cable from your network to the Ethernet connector (
ETH1
or
ETH2
) on the back of the Geomagic Touch.
4. Connect an Ethernet Cable from the back of the device (
ETH1
or
ETH2
) to the appropriate Port on your computer.
5. Connect the power supply as follows:
a. Hook up the Power Supply (use only the supplied power supply with the Geomagic Touch device):
b. Plug the power cord into the power supply. Plug the power cord into an available outlet (for 110V the outlet must be rated for at least
2 Amps, for 220V: 1 Amp). The green status light on the power supply indicates that it is working correctly. Finally plug the power
connector into the connector (Power) on the back of Geomagic Touch device
Connect the Ethernet cords and power cable to the back of the Touch device.
6.
Allow 1-2 minutes for the device to automatically configure the Device Drivers with your Operating System and connect.
NOTE: This configuration only occurs the first time you connect your device.
7. Ensure that the Geomagic Touch Status Indicator Light is lit (it will either be blinking yellow or solid orange if working properly). If it
is not, check all of the connections. If the problem persists, contact Customer Support.
