13
Apply a generous amount of medium or thick CA glue to the slot in the right elevator and
install the right elevator onto the stab with thin CA on the hinges. Hold perfectly straight as
the glue dries, or use masking tape to hold the elevator straight until the glue dries.
If you are using a single HS-225MG (or 5245MG) then you can install it into the elevator
servo slot. If you are using a full-size servo, use the included template to mark the hole for
trimming as shown. Trim the template as necessary to clear the stab.
Use a sharp, new hobby knife to trim the excess wood. Use many light strokes with the
knife, don’t press too hard into the wood. Be patient. Mount the elevator servo with the
output shaft to the rear of the plane.
