ASSEMBLY INSTRUCTIONS
This model offers the option to add COB led strips for night flying. The following instructions
will have steps for assembly
WITH
and
WITHOUT
the LED strips. Steps for assembly using
the LED strips will be prefixed with a letter next to the step number, eg- “1
a
”
1
All faces which are to be glued to other parts need to be given a light sanding (scuff the
surface) to assist with glue adhesion.
2
Cut 10mm sections of skewer and place into alignment holes in the fuselage sections.
NOTE
- It may be required to open up the holes a small amount if the fit is too tight. Do this
by using a 3mm drill bit. Gently spin it in reverse as you insert it into the hole. This will ensure
the bit does not tear the print.
Test fit the sections of the fuse before gluing to ensure a clean fit.