5-4
C
HAPTER
5: C
HANGING
C
ONFIGURATION
S
ETTINGS
Changing Configuration Settings
To change the configuration settings, follow these steps:
1
Click
Tools
on the main screen, shown in Figure 5-1.
The Tools screen appears, as shown in Figure 5-2.
2
Click
Config
.
The Configuration screen appears, as shown in Figure 5-3.
You can change the following PC Card configuration
parameters: I/O Base Address, Interrupt Request Level,
Transceiver Type, Network Driver Optimization, and
Maximum Modem Speed.
If you are using Card Services, the I/O Base Address and the
Interrupt Request Level settings are assigned by Card Services.
If you change these settings here, they will be saved to the
EEPROM, but the PC will still use the values Card Services
allocated at start-up.
3
To change the PC Card configuration settings, scroll
through the values next to each configuration setting
shown in Figure 5-3, until you find the value you want.
The configuration settings and possible values are defined in
the next section.
4
To set the new values, click
Save
, shown in Figure 5-3.
5
Click
Main
to return to the main screen.
This completes the procedure for changing the
configuration settings.
