Removing the 3C589C PC Card
2-5
3
To use the BNC connector on the 3C589C-COMBO cable,
attach the BNC connector to the network cable, as shown
in Figure 2-6.
Figure 2-6
Attaching the BNC Connector to the Network
Once the PC Card is connected to the network, the
installation is complete. To configure the 3C589C PC Card, go
to Chapter 3 if you are on a Novell NetWare network. If you
are on any other network operating system, go to Chapter 4,
Installing the NDIS Driver
.
Removing the 3C589C PC Card
The PC Card can be removed whether the power to the PC is
ON or OFF. Follow these steps to remove the PC Card:
1
Disconnect the cables from the 3C589C PC Card.
2
Remove the PC Card from your PC.
Many PCs have a button or lever to assist in removing the PC
Card. Refer to the instructions provided in your PC manual.
3
Store the PC Card in its original or similar packaging.
This completes the procedure for removing the PC Card.
3C562
INSERT
THIS SIDE UP
10BASE-T Ethernet
and 28.8 Modem
LAN+Modem PC Card
EtherLi
nk III
®
Network cable
BNC connector
for network
®
®
PC Card
connector
