3Com 4210 PWR, Configuration Manual

Page: 513 / 567

Remote-Ping Configuration Example 511
Displaying Remote-Ping Configuration
After the above-mentioned configuration, you can use the display commands to
view the results of the latest test and history information.
Remote-Ping
Configuration
Example
ICMP Test Network requirements
The Switch 4210 serves as the Remote-Ping client. A Remote-Ping ICMP test
between the switch and another switch uses ICMP to test the round trip time (RTT)
for packets generated by the Remote-Ping client to travel to and back from the
destination switch.
Network diagram
Figure 180 Network diagram for the ICMP test
Configuration procedure
■
Configure Remote-Ping Client (Switch A):
# Enable Remote-Ping client.
<4210> system-view
[4210] Remote-Ping-agent enable
# Create a Remote-Ping test group, setting the administrator name to
"administrator" and test tag to "ICMP".
[4210] Remote-Ping administrator icmp
# Configure the test type as icmp .
Configure the number of
consecutive unsuccessful
Remote-Ping probes before
Trap output probe-failtimes times Optional
By default, Trap messages are
sent each time a probe fails.
Table 382 Display Remote-Ping test results
Operation Command Description
Display test history display Remote-Ping history [
administrator-name
operation-tag ] Available in any view.
Display the results of the
latest test display Remote-Ping results [
administrator-name
operation-tag ]
Table 381 Configure the Remote-Ping client to send Trap messages
Operation Command Description
Switch A
Switch B
HWPing Client
IP network
10.1.1.1/8 10.2.2.2/8