3Com 4210 PWR, Configuration Manual

Page: 33 / 567

Logging in through the Console Port 31
[4210-ui-aux0] idle-timeout 6
After the above configuration, you need to modify the configuration of the
terminal emulation utility running on the PC accordingly in the dialog box shown
in Figure 4 to log into the switch successfully.
Configuring Console
Port Login to Require a
Password
Configuration Procedure
Table 15 Console port login configuration with the authentication mode being password
Operation Command Description
Enter system view system-view -
Enter AUX user interface
view user-interface aux 0 -
Configure to authenticate
users using the local
password authentication-mode
password Required
By default, users logging into a switch
through the Console port are not
authenticated; while those logging in
through Modems or Telnet are
authenticated.
Set the local password set authentication
password
{ cipher |
simple } password
Required
Configure
the Console
port Set the baud
rate speed speed-value Optional
The default baud rate of an AUX port
(also the Console port) is 9,600 bps.
Set the check
mode parity { even | none |
odd }
Optional
By default, the check mode of a
Console port is set to
none , that is, no
check bit.
Set the stop
bits stopbits { 1 | 1.5 | 2 } Optional
The default stop bits of a Console port
is 1.
Set the data
bits databits { 7 | 8 } Optional
The default data bits of a Console port
is 8.
Configure the command
level available to users
logging into the user
interface user privilege level
level
Optional
By default, commands of level 3 are
available to users logging into the
AUX user interface.
Make terminal services
available to the user
interface shell Optional
By default, terminal services are
available in all user interfaces.
Set the maximum number
of lines the screen can
contain screen-length
screen-length
Optional
By default, the screen can contain up
to 24 lines.
You can use the screen-length 0
command to disable the function to
display information in pages.