Installing the IntelliJack
11
•
If the end of the cable is terminated with a male connector, connect the
network cable directly into the Ethernet uplink port.
Mounting the IntelliJack
After connecting the IntelliJack to the network, use the two provided screws to
mount the IntelliJack in any standard NEMA-WD6 cubicle opening or wall outlet.
If the cubicle or wall opening has a depth of fewer than 1.5 inches, does not
support the NEMA-WD6 standard, or does not have pre-drilled screw holes,
mount the IntelliJack using the extension ring, as shown below.
NOTE: The extension rings are designed to stack on top of one another. If you
need more than 0.3 inches of clearance, simply snap an additional extension
ring to the back of the IntelliJack.
CAUTION: Make sure the vents along the edges of the IntelliJack faceplate are
clear of any obstructions. If necessary, install the extension ring on recessed
openings to allow airflow to vents.
