3Com 3C16630A, User Manual

Page: 41 / 132

Setup 3 - 13
DUA1663-0BAA0 3
Node (Read-only) This field shows the node address of the repeater
stack, which is learned automatically.
Status (Choice Field) Enabled / Disabled
This field shows whether the data link protocol is enabled. Choose
Disabled if you wish to prevent access for any reason, such as security
considerations.
Data Link Protocol (Read-only) This field shows the name of the IPX
data link layer protocol.
OK (Button) Press [Return] when the OK button is highlighted to action
your selections for this screen. You will be returned to the main menu.
I f you have changed the parameters, you will need to reset the Module
t o effect the changes. Refer to the section “Reset” on page 3-48.
SETUP TRAPS (Button) Press [Return] when the SETUP TRAPS button is
highlighted to set up the parameters for traps (see “Trap Setup” below).
SERIAL PORT (Button) Press [Return] when the SERIAL PORT button is
highlighted to set up the RS-232C port parameters (see “Serial Port
Setup” on page 3-15 ).
CANCEL (Button) Press [Return] when the CANCEL button is
highlighted to abandon this screen without actioning any changes, and
return to the main menu.
Trap Setup
Traps are messages sent across the network to an SNMP network
manager, such as Transcend WorkGroup Manager for Windows. Traps
can alert the system administrator to faults or changes in the stack.
Y our Transcend SNMP network manager may automatically set up the
trap destination addresses for you. Check the documentation
accompanying the product.
You access the Trap Setup screen by selecting the SETUP TRAPS button
on the Setup screen.