8
•
2470HD Time Delay
Installation
Unpacking
Your 2470-HD Time Delay has been carefully inspected and calibrated before shipment to allow
immediate operation upon installation. Check all items for signs of visible damage which may have
occurred during shipment. If any item is damaged, contact the carrier to file a claim.
Keep the packing materials in the event that the unit must be shipped. If the original packaging is
not available, make sure that the following criteria are met:
•
Packaging must be able to withstand the product weight.
•
Product must be held firmly within the package.
•
There must be at least two inches (50mm) of space between the product and outer container.
•
The corners of the product must be protected.
Package Contents
Confirm that all items on the packing list have been received. Contact 360 Systems if any item is
missing.
9
Model 2470-HD Time Delay
9
Keyboard
9
2-Button Wheel Mouse.
9
Software backup on USB memory stick
9
Operations Manual
9
Power cord
9
Warranty Card
The Time Delay is not shipped with a video monitor. Select a VESA-compliant CRT or LCD monitor
capable of a refresh rate of at least 75 Hz.
Note that the Time Delay may not start correctly if an
unsuitable monitor is connected.
If you own more than one Time Delay, it may be appropriate to use a single keyboard, monitor, and
mouse with a KVM switch to select between units. Not all KVM switching systems are compatible.
The KVM switch must supply an active signal to the Time Delay at all times, even when switched away
from it. When first powering up the Time Delay, use only the supplied keyboard and mouse directly
connected. Then test the KVM switch system that will be used thoroughly before installation is
completed.
NOTE: If the mouse and keyboard connections are interchanged, the Time Delay may not
boot up properly.
Be especially careful about this when using extender cables.
Rack Mounting
There are four adhesive-backed rubber feet on the Time Delay. These may need to be removed
when rack mounting the unit.
Cables attached to the rear of the Time Delay should be supported by the rack mounting rails. Do
not support substantial cable weight from the Time Delay.
Remove the front panel to expose the rack screw slots. Fasten the Time Delay into the rack.
Replace the front panel. Tighten the front panel access screws.
