MAXX-1200 Owner’s Manual
Page 51
Programming GPIO Outputs
The MAXX 1200-HD has six General Purpose Outputs, referred to as GPO 1 through GPO 6.
Each GPO can be programmed to go active on the selected channel when one of the following
events occurs:
IDLE
when the transport returns to idle
PAUSED
when the transport is paused
STOPPED
when the transport is stopped
PLAYING
when the transport is playing
RECORDING
when the transport is recording
RAID System Fault
when a RAID or System Fault occurs
NO GENLOCK
when there is no genlock
NO VIDEO INPUT
when there is no video at the selected input
PLAYLIST
Control GPO via playlist.
To program a GPO output, select
EDIT >CONFIGURE >GPO
.
The screen of Figure 11 is
displayed. GPO 1 through 6 are the 6 triggerable outputs. The checkboxes to the right of each
selection represent channel 1, 2 and 3. GPO 6 is shown with the trigger option pulldown
expanded.
1.
To activate one of the GPO, pulldown the event menu and select which event will
activate the GPO.
2.
Select an associated channel where applicable by checking the channel checkbox.
3.
Click
APPLY
to activate.
Figure 11 - GPO Configuration Screen
