8
7. SWITCHING ON FOR THE FIRST TIME
DO NOT OVERLOOK
Before starting the air curtain with an RF control module, check the following:
•
Did you leave any tools or items inside the curtain which could damage it?
•
There a corresponding el. power supply available including sufficient protection.
•
Did you close the air curtain correctly?
Carefully read the following chapter before connecting the air curtain.
8. CONTROLS
8.1 DESCRIPTION OF THE REGULATION AND ITS CONTOLS
Air curtain without a heater:
Start the device by pressing the
button on the remote control. Then you can use the speed button
to increase or
to decrease fan speed. Selected fan speed is indicated by lights on the integrated control panel. Turn the device off again using
the
button.
Air curtain with an el. heater:
Start the device by pressing the
button on the remote control. Then you can use the speed button
to increase or
to de-
crease fan speed. Use the
button to select whether the heater will be on or off. The operation of the fan and the electric heater
is indicated by lights on the integrated control panel. Turn the device off again using the
button. When the device is turned off,
it automatically performs aftercooling of the electric heating element for 30 seconds and then turns itself off. The aftercooling of
the heat exchanger is indicated by a flashing speed 1 on integrated panel.
Programming (pairing):
This mode is active 30 seconds after power ON of unit (when there was no power supply before).
Press all four buttons on controller at least of 4 seconds. If unit will blinking with fan 1 and fan 2 speed simultaneously, then pairing
was succesfull. If blinking is alternately, then controller is already paired, or there was reached maximum count of controllers (max.
60 controllers per unit).
ON/OFF
ON/OFF
ON/OFF
