Basic Functions
4.1
34
switches into the HandsFree mode too. This is signalled by the button LED. Now you
can hang up the handset without terminating the call.
Call Slot
Use the function to make multiple calls from one terminal by holding the previous call
and setting up a new call using another call slot. By default, each terminal has three
call slots.
Use:
Push the unused ("switched-off") call slot button during a call. The active call will be
put on hold as with the Flash function, you will hear the dialtone and the held user will
hear pre-defined music. If there are more calls in your terminal call slots, you can
switch them using the respective call slot buttons. The active call slot LED is shining
while the held call slot LED is flashing. The unused call slot LED is off.
Intercom
Intercom is a special type of call where a predefined telephone number is dialled by
pressing the Intercom function button and the called station receives the call
automatically in the HandsFree mode. The function is suitable for flexible
communication – you can speak the moment you push the button.
The Intercom function works with the
2N® StarPoint 500
telephones only; if a
different telephone type is used, the call is not answered automatically.
Use:
Press and keep pressed the button with the Intercom function. Start speaking when
you hear a beep. The called user answers the call automatically in the HandsFree
mode. The called party gets an acoustic signal before the call. Keep the button
pressed during the whole call. Release the button to terminate the connection.
Mute
Use the function to temporarily mute the microphone during a call.
Use:
Push the function button during a call. The opponent cannot hear you. The muted
state is signalled by a flashing button LED indicator. Re-push the button to re-activate
the microphone.
Call Recording
Use the function to enable call recording. This function is based on the PBX
administrators's permission to record.
