2N TELEKOMUNIKACE a.s., www.2n.cz
27/72
1.
2.
Electric Lock Connection
Make sure that the power supply is able to supply the required current. Connect the
supply and lock as shown in the figure:
Separate Backlight and Electric Lock Supply
Separate power supplies are necessary e.g. where the lock requires voltage higher
than 12 V. In this case, an additional power supply (12V) must be used to illuminate the
button backlight - see the figure below.
Mounting Completion
Having connected all the wires, make sure that the bushings, if used, are
tightened properly and the RJ-45 connector is inserted in the PCB connector (if
used).
Replace the front cover carefully. Make sure that the wires inside the device
leave enough space for the front cover assembly. Tighten the four screws
thoroughly with the wrench enclosed (Torx 20) to make the panel fit tightly to
the metal chassis.
