2N ATEUS 501101E, User Manual, Page: 30 / 57

28
5.4. Remote Programming by PC
5.4.1. Remote Supervision Purpose
Remote programming by PC has much wider possibilities than programming by phone
(see table in chapter 5.1), but it is also much comfortable and easy to survey. Generally,
remote programming is recommended if it is necessary to program more parameters, or
read them.
Because model 501101 is not equipped with any "cable" interface, it cannot be
connected to PC directly, but only by data connection via GSM network. Remote
supervision allows reading and changing the GSM gateway configuration remotely as
well as reading the contents of the service buffer, thus saving time of servicing
technicians enabling them to solve some problems remotely.
5.4.2. Programming tool – GSM program
Basic function of GSM program is to view and edit all parameters of GSM gateway.
Parameters are grouped in windows, which are according with parameter tables in
chapter 6 of this manual. Help and hints are available for all parameters, as well as a
choice of basic set-up. You can add your own notes and save all settings as a file for
future use. Parameters can be up- or downloaded, but some are read-only or write-only;
e.g. passwords cannot be read, and serial number cannot be overwritten.
5.4.3. Viewing of service buffer
Complete content of service buffer can be viewed on PC and stored as a file - all
monitored events (up to 200 in all) incl. time and date of each. When service buffer is full,
oldest events are overwritten by newest; i.e. buffer is permanently full of "fresh"
information. Watched event types can be selected by mask, see chapter 6.5.
5.4.4. What You Need to Run Remote Supervision
On GSM gateway:
1. The GSM gateway must be equipped with a
SIM card supporting data transmission
.
2. Parameters required for remote supervision must be selected in the GSM gateway.
On PC:
1. You need to know the GSM gateway service password.
2. The PC must be equipped with a reliable modem (analog, ISDN, or GSM), or a GSM gateway
made by 2N, which works in the data mode. If the PC is equipped with an analog modem, it has
to be connected to a CLIP-sending exchange (calling line identification presentation).
3. The ‚incognito‘ function
may not
be activated on PC side.
Important warning!
Once programmed for remote supervision by selected line, GSM gateway cannot receive an
ordinary call from this line. The GSM gateway with the said selection regards every call
containing the supervisor CLIP as a remote supervision attempt. Hence, to make such a call,
you should use another line or another SIM card, or the ‚incognito‘ function, or make a call in
direction from client’s GSM gateway to the Supervision Center.