2N 9137111CKU, Installation Manual

Page: 55 / 113

Installation manual 2N® IP Vario
55 / 113
1.
2.
3.
4.
The terminal block is included in the package. To adjust an already installed
2N
®
IP Vario , disconnect it IP from the power supply. Then pull to remove the terminal
block from the printed circuit board.
Insert the wires under the respective terminals.
Tighten the terminals using a flat screwdriver.
Replace the terminal block to the printed circuit board.
Induction loop connection
The JST SHR-02V-S connector type is required to connect the induction loop output.
Ethernet Connection
For the connections and meanings of the wires see the table below. Join UTP cable wires 4
(blue) and 5 (white-blue) and attach them under terminal 6
on 2N
®
IP Vario in the same way.
Join wires 7 and 8 and place them under terminal 5 of 2N
®
IP Vario .
Terminal Block Connections
•
Caution
Make sure that the cables leading through the 2N
®
IP Vario cover bottom groove
are installed properly. For the correct installation of the cables refer to Figure 2.7.
