2N TELEKOMUNIKACE a.s., www.2n.cz
59/82
The input pin (IN1, IN2) and logic output (REL 1, REL 2) parameters are identical for
both the outputs.
Upon the
power up / restart, the states of the two outputs are OFF and
2N LiftGate
®
switch to ON in a few seconds (after the system start up is completed) if configured
so. If the Duration parameter is set to 0, the required ON / OFF state will be
permanent, otherwise the required state holds as set in the Duration parameter and
then switches back. In case the Event parameter is set to a valid value, the output
closes / opens whenever the set event occurs.
The output states can also be controlled using SMS or HTTP commands.
– initial output state at system power up.
Output 1, 2 start state
– ON state duration (in tenths of a second).
Output 1,2 ON duration
– OFF state duration (in tenths of a second).
Output 1,2 OFF duration
– event that initiates a state change to ON.
Output 1,2 ON event
– event that initiates a state change to OFF.
Output 1,2 OFF event