![background image](http://html.mh-extra.com/html/2m-technology/vsc-3000a/vsc-3000a_operating-manual_439729015.webp)
1. Before raising the tower it
is
be necessary to
install
the
top devices and adjust them to the required condition.
2. Check mast ropes for excessive wear or damage. Make sure the ropes are properly centered in each pulley.
Check the mast electrical cord for damage.
WARNING
The trailer must be leveled with the outriggers extended before raising the tower. The outriggers
must remain extended while the tower is up. Failure to level the trailer or extend the outriggers
will severely reduce the stability of the unit and could allow the tower to tip and fall.
WARNING
Do not
operate
the unit
if the insulation on the electrical cord is cut or worn through.
Bare wires in contact with the mast or frame may energize the trailer and cause
electrocution.
Repair or replace cord.
3.
Before raising the tower, make sure the steel ropes are orderly and tightened (
A
). If slack, it will lead to
steel ropes
wear
and even breakage.
Crank up the mast
clockwise (
B
) and extend it to the required height. If it is
extended to the maximum height,
please insert th
e safety
locking pin (
C
).
Extend the mast slowly, making sure
that the electrical cord is extending at the
top sections of the
mast. If, for any reason, the cable begins to develop
slack or any of the tower sections get stuck,
STOP
IMMEDIATELY and contact an authorized service center.
1
5
A
B
C
RAISING THE TOWER