247Security Inc. | 4400 North Point Parkway, Suite # 158, Alpharetta, GA 30022, USA | 1-866-693-7492 | www.247securityinc.com
ZEUS mDVR
USERS MANUAL
19
d)
At the Standby stage
•
After the shutdown delay, the files on SD will copy to HD. If the file copy is completely, the SD
will be formatted to FAT32.
•
After ignition is off, after shutdown delay, the Tab101 downloading will start first. After the
TAB101 downloading, if HBD recording is enabled, then the WIFI is not turned on, the GPS is
powered off and the cameras are powered off. After that, the HD will be turned on and the
files in SD will be copied to HD. If the file copy is completely, the SD will be formatted to FAT32.
Then WIFI is turned on. The system goes to standby mode.
•
If the files from SD are not completely copied to HD, the SD will not be formatted
•
During the file copy from SD to HD, if the live view or play archived happens, the file copy from
SD to HD is paused. After the live view or play archived is done, the file copy from SD to HD
resumes.
•
System starts uploading data if this feature is enabled at setup page. The smart uploading only
uploads data from HD.
e)
The process of disk copy from Flash to Hard disk
1.
Create the file list on Flash
2.
Check whether the file to be copied exists on Hard disk
3.
If the file doesn’t exist, check whether the file is lock file or not. If it is lock file . Check whether
it was copied before or not, if it was, then change the lock file to no lock file
4.
If the file exists, then check the size of file, if the size of file on hard disk is equal to the size of
file to be copied, check next file and go to step2.
5.
Copy the file from SD to Hard disk
6.
Check next file and go Step2 until all files have been checked
f)
The procedure of disk key lock off
1.
Flash the Hard disk LED
2.
DVR stops recording and release all the resource
3.
Un-mount all the disks
4.
Send MCU command to turn off the power
4
CONNECTING TO DVR
Please make sure you already read Item “1.3 Warning POE feature” before reading setup.
4.1
IP CONFIGURATION
The DVR default IP address is 192.168.1.100. The DVR is set up with a STATIC IP address to allow for a direct
connection with a cross-over cable. During installation the DVR can be connected to a laptop allowing the
installer to preview the cameras for aiming purposes.