Chapter 12 Remote Management
VMG4005-B50A/B60A User’s Guide
43
The following table describes the fields in this screen.
12.3 Trust Domain
Use this screen to view a list of public IP addresses which are allowed to access the VMG through the
services configured in the
Maintenance > Remote Management > MGMT Services
screen.
Click
Maintenance
>
Remote Management > Trust Domain
to open the following screen.
Note: If this list is empty, all public IP addresses cannot access the VMG from the WAN through
the specified services.
Table 17 Maintenance > Remote Management > MGMT Services
LABEL
DESCRIPTION
WAN Interface
used for services
Select
Any_WAN
to have the VMG automatically activate the remote management service
when any WAN connection is up.
Select
Multi_WAN
and then select one or more WAN connections to have the VMG activate the
remote management service when the selected WAN connections are up.
Service
This is the service you may use to access the VMG.
•
HTTP
provides a non secured way.
•
HTTPS
is the secured version of HTTP, it makes sure that your data cannot be read during
transmission.
•
FTP
is the most common way of communication between two devices.
•
TELNET
provides a way to control your VMG remotely.
•
SSH
prevents leakage of data during remote management. Additionally, it can encrypt all
transmitted data.
•
PING
is a diagnostic tool that can check if your VMG is connected to the Internet.
LAN
Select the
Enable
check box for the corresponding services that you want to allow access to the
VMG from the LAN.
WAN
Select the
Enable
check box for the corresponding services that you want to allow access to the
VMG from all WAN connections.
Trust Domain
Select the
Enable
check box for the corresponding services that you want to allow access to the
VMG from the trusted hosts configured in the
Maintenance > Remote MGMT > Trust Domain
screen.
If you only want certain WAN connections to have access to the VMG using the corresponding
services, then clear
WAN
, select
Trust Domain
and configure the allowed IP address(es) in the
Trust Domain
screen.
Port
You may change the server port number for a service if needed, however you must use the
same port number in order to use that service for remote management.
Cancel
Click
Cancel
to restore your previously saved settings.
Apply
Click
Apply
to save your changes back to the VMG.
Содержание VMG4005-B50A
