2. SMT (System Management Terminal). Access the SMT via:
•
Telnet
•
Console port using terminal emulation software
Procedure For Web Configurator Configuration
1. Launch your web browser and enter “192.168.1.1” as the URL.
2. Type “admin” as the user name, "1234" (default) as the password and press
ENTER
.
3. You should now see the
SITE
MAP
screen. Click the help icon (located in the upper right portion all screens) for online
HTML help.
Procedure For SMT Configuration via Telnet
1. Launch a Telnet program. In Windows, click
Start
and then
Run
. Type “Telnet” followed by a space and the IP address
of the Prestige, (192.168.1.1 is the default) and click
OK
to display the password screen.
2. Enter the password (1234 is the default), to access the SMT main menu. As you type a password, the screen displays an
“*
”
for each character you type.
Procedure For SMT Configuration via Console Port
1. Configure a terminal emulation communications program as follows: VT100 terminal emulation, no parity, 8 data bits, 1
stop bit, data flow set to none, 9600 bps port speed.
2. Press
ENTER
to display the SMT password screen. The default password is “1234”.
Use the ISP information you gathered to configure SMT menu 4 and access the Internet. Refer to your
User’s Guide
for
details.
T
T
r
r
o
o
u
u
b
b
l
l
e
e
s
s
h
h
o
o
o
o
t
t
i
i
n
n
g
g
PROBLEM
CORRECTIVE ACTION
The PWR and/or SYS LED
are off.
Make sure the Prestige is connected to the correct power adapter, the power adapter is
plugged into an adequate power supply and the Prestige power switch is turned on.
Turn the Prestige off and on. If the error persists, you may have a hardware problem. In this
case, you should contact your vendor.
The LAN LED won’t turn on.
Check the cable connection to the Prestige LAN port.
Make sure you are using a crossover Ethernet cable if you are connecting the Prestige
directly to one computer and a straight-through cable if you are connecting your Prestige to
LAN computers via a hub.
Make sure your computer NIC (Network Interface Card) is working properly.
The DSL LED is off.
Check the connection between the Prestige DSL port and the wall jack.
Check to see if the Prestige is connected to your computer’s serial port.
I cannot access the Prestige
via the console port.
Check to see if the communications program is configured correctly. Refer to the defaults in
the
Procedure For SMT Configuration via Console Port
section.
I cannot access the SMT
menu.
The default SMT password is “1234”. If you have changed the password and have now
forgotten it, you will need to upload the default configuration file (see
User’s Guide
).
I cannot access the web
configurator.
Check that your computer IP address and the Prestige IP address are on the same subnet.
If you changed the Prestige default LAN IP address then enter the new one as the URL.
Remove any filters you have applied in menu 3.1 (LAN) or in menu 11.5 (WAN) to block web
service.
