Prestige 623 Series Dual-link ADSL Router Quick Start Guide
3
PORT
CONNECTION
2. LAN
10/100M
Connect to a computer using a crossover Ethernet cable or to a hub using a straight-
through Ethernet cable.
3. POWER
Do this last. Connect to a power source using the supplied power adapter.
After you’ve made the connections, connect the power adapter to a power supply and push in the power
button to turn on the Prestige. Look at the front panel LEDs.
Proceed to install the USB driver if you want to connect the Prestige to the USB port on the computer. Refer
to the
Installing USB Driver
section.
USB
The USB port is useful when a computer does not have a network card. Connect the USB port
during the USB driver installation.
RESET
You only need to use this button if you’ve forgotten the Prestige’s administrative account
password or IP addresses. It returns the Prestige to the factory defaults (see your
User’s Guide
for details).
Front Panel LED
When the Prestige is turned on, the
PWR
LED turns on. The
SYS
LED turns steady on if the system self-
test is successful. The appropriate
LAN
and/or
USB
LEDs turn on if they are properly connected.
Prestige Factory Defaults
This
Quick Start Guide
provides a default configuration that should be compatible with your home or small
office network setup. Refer to the
User’s Guide
for additional configuration instructions.
PRESTIGE FACTORY DEFAULTS
LAN IP Address
192.168.1.1
Default User name
admin
USB IP Address
192.168.1.2
Default Password
1234
Subnet Mask
255.255.255.0
DHCP IP Pool
192.168.1.3 – 192.168.1.34