Chapter 8 Routing
PMG2006-T20A User’s Guide
68
8.4.1 Add/Edit Policy Route
Click
Add New Policy Route
in the
Policy Route
screen or click the
Edit
icon next to a policy. Use this
screen to configure the required information for a policy route.
Figure 35
Policy Route: Add/Edit
The following table describes the labels in this screen.
8.5 RIP
Routing Information Protocol (RIP, RFC 1058 and RFC 1389) allows a device to exchange routing
information with other routers.
Table 22 Policy Route: Add/Edit
LABEL
DESCRIPTION
Active
Select to enable or disable this policy route.
Route Name
Enter a descriptive name of up to 8 printable English keyboard characters, not including spaces.
Source IP
Address
Enter the source IP address.
Source Subnet
Mask
Enter the source subnet mask address.
Protocol
Select the transport layer protocol (
TCP
or
UDP
).
Source Port
Enter the source port number.
Source MAC
Enter the source MAC address.
Source Interface Type the name of the interface from which the matched traffic is sent.
WAN Interface
Select a WAN interface through which the traffic is sent. You must have the WAN interface(s)
already configured in the
Broadband
screens.
OK
Click
OK
to save your changes.
Cancel
Click
Cancel
to exit this screen without saving.