ZyXEL Communications ONU-2024 Series, Руководство пользователя

Страница: 228 / 268

Chapter 30 Cluster Management
ONU User’s Guide
228
VID This is the VLAN ID and is only applicable if the ONU is set to 802.1Q VLAN. All
switches must be directly connected and in the same VLAN group to belong to
the same cluster. Switches that are not in the same VLAN group are not visible
in the
Clustering Candidates list. This field is ignored if the Clustering
Manager is using Port-based VLAN.
Apply Click Apply to save your changes to the ONU’s run-time memory. The ONU
loses these changes if it is turned off or loses power, so use the Save link on the
top navigation panel to save your changes to the non-volatile memory when you
are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Clustering
Candidate The following fields relate to the switches that are potential cluster members.
List A list of suitable candidates found by auto-discovery is shown here. The
switches must be directly connected. Directly connected switches that are set to
be cluster managers will not be visible in the
Clustering Candidate list.
Switches that are not in the same management VLAN group will not be visible in
the
Clustering Candidate list.
Password Each cluster member’s password is its web configurator password. Select a
member in the
Clustering Candidate list and then enter its web configurator
password. If that switch administrator changes the web configurator password
afterwards, then it cannot be managed from the
Cluster Manager . Its Status is
displayed as Error in the Cluster Management Status screen and a warning
icon ( ) appears in the member summary list below.
If multiple devices have the same password then hold [SHIFT] and click those
switches to select them. Then enter their common web configurator password.
Add Click Add to save your changes to the ONU’s run-time memory. The ONU loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are
done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Refresh Click Refresh to perform auto-discovery again to list potential cluster members.
The next summary table shows the information for the clustering members configured.
Index This is the index number of a cluster member switch.
MacAddr This is the cluster member switch’s hardware MAC address.
Name This is the cluster member switch’s System Name .
Model This is the cluster member switch’s model name.
Remove Select this checkbox and then click the Remove button to remove a cluster
member switch from the cluster.
Cancel Click Cancel to begin configuring this screen afresh.
Table 93 Management > Clustering Management > Configuration (continued)
LABEL DESCRIPTION