Zylight Go-Panel, Инструкция пользователя

Страница: 6 / 20

Page 5
Go-Panel Use & Operation
Mounting the Go-Panel:
The integrated friction hinge has a 5/8” receiver and can
be mounted to a light stand or C-Clamp. Double check that all knobs and bolts are
tightened securely after each time the fixture is aimed or installed. If used overhead
on a grid, truss, or batten, please secure the fixture and barn doors with a safety
cable in accordance to local regulations.
To adjust the tilt of the fixture, firmly hold the light stand and push on the top of the
Go-Panel. The tension on the friction hinge is not adjustable. It is rated to tens of
thousands of cycles. Do not attempt to loosen the screws on the friction hinge as this
will weaken the stability of the fixture and create a safety hazard. Should your friction
hinge need service, please contact the Zylight service department.
The Go-Panel has an integrated twist-and-lock ball mount receiver plate. This
plate may be used with existing lollipop style mounting systems and doubles as an
optional battery or AC adaptor mounts for the Go-Panel. (See the next section
regarding power mounting options.)
Power Connection
All cord connections from the Power Supply to the fixture should be done prior to
connecting to mains power!
Use GFCI surge protectors whenever possible to protect your equipment against
voltage spikes and for your safety.
Power Supply:
The Zylight Go-Panel is powered through a 4-pin XLR connector by
either the included Worldwide AC Adapter (Part # 1002555), or by Zylight Go-Panel
Battery Plates (14.4V).
First, insert the 4-pin XLR connector to the DC-Input jack on
the fixture before connecting the power supply to main power!
AC Operation:
Use only the included Worldwide AC Adapter (Part # 1002555).
During use, the AC Adapter can be held by either the AC Adapter Bag (Part # 19-
02042) or directly mounted to the fixture back plate utilizing the optional Go-Panel AC
Mounting Plate (Part # 1005148).
The AC Adapter Bag (Part # 19-02042) securely holds the AC Adapter to hang on a
light stand or another secure location via the attached quick release strap. The AC
cord passes through the bottom of the bag with the 4-pin XLR exiting at the top. Be
sure to tighten the cinch cord to secure the Power Supply.
The AC Mounting Plate (Part # 1005148) works on a twist and lock principle. Match
the four pins on the AC plate to the four holes on the back of the fixture and turn
clockwise until the pull pin clicks into place. Mount the power supply via the hook
and loop strap and then connect the 4-Pin XLR to the DC Input on the fixture before
connection to main power.