Zylight F8-200, Инструкция пользователя

Страница: 13 / 20

Page 12
DMX Control
Operating the F8-200 LED Fresnel from a DMX controller gives users the
option to create unique lighting looks. The F8 has a single 5-pin DMX Breakout
connector on the rear of the light to link DMX connections between lights
when used in a DMX chain. The use of a DMX Interface Box (P/N 26-02019) is
necessary to integrate the F8-200 into DMX chain installations by providing
connections for looping through both DMX IN and DMX OUT data.
The F8 DMX Interface Box plugs directly into the 5-pin DMX Breakout
connector built in to the rear of the F8-200. If the F8-200 will be the last light
in your DMX chain, you may plug a 5-pin XLR DMX cable directly into the 5-pin
DMX Breakout Jack. The F8 is a self-terminating device and the use of a DMX
terminator or Zylight DMX interface box will not be necessary when the F8 is
the last light in your DMX chain, or if you are running separate lines to each of
your fixtures.
When connecting from fixture to fixture, use of the DMX Interface Box is
necessary for correct DMX connections. Not following these steps for DMX
connection can result in erratic behavior. The DMX Interface Box mounts to
the bottom of either side of the F8 yoke. (see image below)
Zylight DMX Interface Box (P/N 26-02019)