FV237 Rev. E 11/9/11
Page 3
6
7.)
VISUAL INDICATOR GUIDE
USER-IN-VIEW L.E.D.
Yellow light flashes 3 times – after
5-second delay – when a user is in view. The yellow light
flashes constantly when a user is in view during the 10-minute
start-up sequence.
OBJECT LOCK SENSOR
BATTERY L.E.D.
Red light flashes indicating it is time to
replace batteries with 4 new “C” batteries.
COURTESY MANUAL FLUSH BUTTON
Allows manual
activation of flush when needed.
STEP A
Use battery compartment
wrench to remove battery compartment
tray.
STEP B
Pull cover off by rotating battery
side forward and out.
STEP C
Sensor Adjustor Tool comes in
a built-in storage pocket. Replace after use.
8.)
ADJUSTING YOUR E-Z FLUSH
6.)
ACTIVATION
Using supplied battery compartment wrench,
remove battery compartment from the E-Z
Flush™ unit.
Load batteries into compartment tray (note
position of batteries in tray), and reinstall
battery tray into the E-Z Flush unit.
Secure tray with battery compartment wrench. The last three
turns of the wrench will activate the E-Z Flush unit. The E-Z
Flush System is now operational.
Your E-Z Flush unit comes preset from the factory. If special
circumstances require adjustment of the activation distance,
see Appendix A – Adjusting Your E-Z Flush.
The E-Z Flush unit has a 10-minute start-up sequence in which
the Object Lock Sensor will flash the User-In-View
yellow L.E.D.
continuously as long as a user is in view. After the start-up
sequence is completed and when the Object Lock Sensor has
a user in view, the User-In-View
yellow L.E.D.
will flash only 3
times after a 5-second delay. This delay prevents needless
flushes when someone walks by. Sensor units should not be
located across from each other or in close proximity to highly
reflective surfaces.
