Page
|
6
Setup
Instructions
WIRELESS
BRIDGE
SETUP
Wireless
Bridge
/
Extender
Information
A
wireless
bridge
is
a
network
device
that
connects
to
an
existing
wireless
network
and
then
converts
the
wireless
network
signal
into
a
wired
one
(CAT
‐
5).
A
wireless
extender
is
a
network
device
that
extends
the
range
of
an
existing
wireless
router’s
signal.
Follow
these
instructions
to
setup
the
ZuniDigital
Wireless
Bridge.
For
best
performance,
we
recommend
setting
up
the
ZuniConnect
Bridge
close
to
where
you
intend
to
use
it.
For
the
best
results
do
not
place
the
ZuniDigital
Travel
Connect
near
any
large
metal
objects
or
magnets
(like
those
found
in
speakers).
Also
note
that
elevating
the
travel
router
from
the
floor
will
increase
wireless
broadcast
signal
performance
and
range.
Step
1
–
Attach
Antennas
Remove
the
protective
film
from
the
surge
protector
and
attach
the
(2)
SMA
antennas
to
the
main
body.
The
antennas
should
be
secure,
but
do
not
over
‐
tighten
them.
Step
2
–
Power
ON
Plug
the
surge
protector
into
a
wall
outlet
and
then
flip
the
Main
Power
Switch
to
the
RESET
/
ON
position.
Then
slide
the
Ethernet
Bridge
Green
Power
Mode
to
the
CONSTANT
position.
Step
3
–
Attach
RJ
‐
45
Ethernet
Cable
Plug
one
end
of
an
RJ
‐
45
Ethernet
cable
into
port
#1
on
the
wireless
bridge,
and
then
plug
the
other
end
of
the
cable
into
a
computer’s
Ethernet
port.
This
computer
will
be
used
to
configure
the
wireless
bridge
and
thus
connect
it
to
an
existing
wireless
network.
