Zultys MXmeeting M1000, Руководство администратора

Страница: 6 / 42

MXmeeting Release v6.0 M200/M500 & M800/M1000
Admin Guide (0000000202)/ Revision 7 5/9/2016
© 2016 Zultys, Inc. No reproduction of distribution without permission
Page 6 of 42
Technical Publications

Wait for 1 minute

Type “turbomeeting” as the Username and “password” as the Password

Wait for up to a couple of minutes and you will be connected to the Fedora 4 desktop.

Open a browser by clicking the browser icon on the top banner

This will take you to the MXmeeting web login page (Figure 1.2)
 Follow the sections below to configure the appliance using the browser.
1.4 Crossover-cable
The crossover-cable is only used for the M200/M500 appliance. Before you use the crossover-
cable method, configure your computer (in any operating system) with the following IP setting:

IP Address: 192.168.1.100

Subnet Mask: 255.255.255.0
Next, do the following:

Disconnect your computer from any network including the wireless

Power on the M200/M500 (as described above)

Wait for the ready light to turn green. This usually takes about 90 seconds

Connect the M200/M500 to your computer using the included crossover-cable or any
Internet cable

Open a browser on your computer and type http://192.168.1.192 . The home page
(Figure 1.1) should display.
Once you have accessed the meeting server, you are ready to configure the server. Do not
disconnect your computer from the meeting server before you complete the configuration
described in the next section. After the configuration, connect the M200/M500 to your network
using a regular Ethernet cable (which is not included).
Note that after you change the system IP settings, the web page will hang. You will need to use
the new IP address to access the appliance.
2 Configuring the MXmeeting Web Conferencing Appliance