Using the OUTSIDE mode:
1. Press Mode, the OUTSIDE icon flashes.
2. Press Enter, shows OUTSIDE, CO2 and ppm flashes. Press the Up/Down to adjust the data.
3. Press Enter to save the setting. After the modification, the VENT Rate will change.
*Note: Ventilation rate represents how much air is introduced into the indoor space from outside. Low numbers indicate low ventilation rates and potentially poor air
quality. High levels indicate excessive ventilation and potential excessive energy usage. To obtain an accurate measurement, reading should be taken 2~3 hours
after occupancy has stabilized in a space or at a peak in daily CO2 concentrations. For indoor air quality control, CO2 value is an indicator of ventilation rate.
400ppm (Parts Per Million) is the default CO2 concentration outside (according to ASHRAE: American Society of Heating, Refrigeration and Air conditioning
Engineers.
Using the CALI (calibration) mode:
1. Press Mode, The CALI icon flashes.
2. Press Enter, the CALI icon on the display. Adjust the CO2 reading by Up/Down button.
3. Press Mode for more than 10sec,CALIBRATING flashes. Calibration will be done automatically after ahout 3 minute and the LCD will display “Pass” or
“Fail.” If it shows “Fail,” please try again.
Using the DATALOGGER mode:
1. Press Mode, DATALOGGER icon flashes.
2. Press Enter, CO2 reading and Temperature show on the LCD.
3. Press Up/Down to page up/down the reading.
*Note: With the Built-in Datalogger, ZG1163 can provide the past CO2 and temperature reading within the past 24 hours. The log interval is 30 minutes per data. ZG1163
is connected with power and used for the first time. If the working time is more than 30 minutes, ZG1163 will have CO2 & temperature reading in datalogger, if the
working time is less than 30 minutes, the LCD will display “NULL” while using the datalogger function.
Using the MAX MIN mode:
*Note: With the Built-in MAX MIN mode, ZG1163 can provide the Maximum and Minimum CO2 readings since the device has last been turned on. If users press up/down to
clear the MAX and MIN CO2 reading record, ZG1163 will provide the new MAX and MIN CO2 reading from that time.
Using the “rcFS” Mode:
1. Press Mode, The rcFS icon flashes.
2. Press Enter, the icon “no” shows on the LCD, Press the Up/Down to select the no/yes.
3. After selecting, press Enter to save the setting.
*Note: If the user sets the data or calibrates the ZG1163 incorrectly, use the rcFS (recover the factory Setting) to come back the default factory setting.
SPECIFICATIONS
Method - NDIR
Display - LCD
Independent CO
2
and Temperature readings
1. Press Mode, the MAX MIN icon flashes.
2. Press Enter, the MAX and MIN CO2 reading alternatively shows.
3. Press Down and the “CLr” will flash on the LCD. Press Enter to CLEAR the MAX and MIN record.
