3. Low Voltage Protection Threshold ( Cutoff Threshold )
a. Turn on your radio and set the throttle stick to top positon (100%)
b. Plug the battery pack into your controller
c. Wait for 2 seconds, you will hear 4 groups of two sets of fast beeps, after this you will hear
four single beeps to indicate you have successfully entered the programming mode
d. When you hear three short beeps “Beep-Beep-Beep” means you are in the Low Voltage
Protection Threshold menu, please choose your desired value by pulling the throttle stick to the
lowest position.
e. The system will automatically enter into next setting item when you nish one . If you do not
want to change other settings, unplug the power to exit.
1)
For Li-xx packs- number of cells are automatically calculated and requires no user input
apart from dening the battery type. This ESC provides 3 setting options for the low voltage
protection threshold ; Low (2.8V)/ Medium (3.0V)/ High (3.2V). For example : the voltage
cutoff options for an 11.1V/ 3 cell Li-Po pack would be 8.4V (Low)/ 9.0V(Med)/ 9.6V(High)
2)
For Ni-xx packs-low / medium / high cutoff voltages are 50%/60%/65% of the initial
voltage of the battery pack.. For example: A fully charged 6 cell NiMh pack's voltage is 1.44V
x 6=8.64V,when “LOW” cutoff voltage is set, the cutoff voltage is: 8.64V x 50%=4.3V and
when “Medium” of “High” is set, the cutoff voltage is now 8.64V X 65%=5.61V.
4. Factory Setup Defaults:
a. Turn on your radio and set the throttle stick to top positon (100%)
b. Plug the battery pack into your controller
c. Wait for 2 seconds, you will hear 4 groups of two sets of fast beeps, after this you will hear
four single beeps to indicate you have successfully entered the programming mode
d. When you hear four short beeps “Beep-Beep-Beep-Beep” means you are in the Factory
Setup Defaults menu, please choose your desired value by pulling the throttle stick to the
lowest position.
e. The system will automatically enter into next setting item when you nish one . If you do not
want to change other settings, unplug the power to exit.
Restore- Sets the ESC back to factory default settings;
Brake Type
：
Brake Off
Battery Type
：
LiPo with Automatic Cell detective
Cut Off Voltage Threshold
：
3.0V/60%
Motor Timing
：
Auto
SBEC Voltage Output 5.0V
Governor Mode
：
RPM OFF
Motor Rotation
：
Forward
Start Up Strength
：
30%
Low Voltage Cut Off Type
：
Reduce Power
5
