ZTEWelink Z-Wave ZM5202, Руководство по разработке аппаратного обеспечения

Страница: 20 / 61

Hardware Development Guide of Module Product
12 All Rights reserved, No Spreading abroad without Permission of ZTEWelink
PIN Signal Definition
Pin
Voltage
I/O PIN Attribute
PU/PD
Status
Remark
1 ANT_MAIN -- AI,
AO Main antenna
feedback point
-- Mandatory
2 GND -- -- Ground -- Mandatory
3 JTAG_RESOUT_N P1 DI JTAG reset LGA -- If it is not used, NC
4 PON_RST_N P1 DI Module reset -- If it is not used, NC
5 POWER_ON P1 DI Power-on/Power-off
PIN PU Mandatory
6 AP_READY P1 DI Module queries AP
sleep status -- If it is not used, NC
7 I2C_SCL P1 B I2C clock -- If it is not used, NC
8 I2C_SDA P1 B I2C data -- If it is not used, NC
9 MODULE_READY P1 DO AP queries Module
sleep status
-- If it is not used, NC
10 AP_WAKEUP_MO
DULE P1 DI AP wakes up Module -- Low-power level
wakeup. To make the
module standby, the
primary server needs to
raise up this low signal.
If it is not used, NC
11 MODULE
_WAKEUP_AP P1 DO Module wakes up AP -- If it is not used, NC
12 GND -- -- -- -- Mandatory
13 NC -- -- -- -- --
14 GND -- -- -- -- Mandatory
15 NC -- -- -- -- --
16 NC -- -- -- -- --
17 NC -- -- -- -- --
18 NC -- -- -- -- --
19 MODULE_POWER
ON P1 DO MODULE power-on
status indicator
-- If it is not used, NC
20 LED_GREEN P1 AI Signal indicator
interface
-- If it is not used, NC
21 LED_RED P1 AI Signal indicator
interface
-- If it is not used, NC